Cabletron Systems T2015 Installationsanleitung PDF herunterladen (Seite 98)

88 Installation Guide for Clients

• If the list contains all needed protocols, proceed to step 5.

• If the list does not contain a needed protocol, and if you have a

supplemental drivers disk containing that protocol, you can copy

the protocol to the computer by choosing the Other Protocol

button and following the instructions that appear on your screen.

After the protocol is copied, you will return to the Network

Protocols dialog box and the copied protocol will be added to the

list of available protocols.

5. Select one or more protocols to be bound to the selected network

adapter driver by selecting the check box at the left of the protocol.

A protocol is selected ([X]) or cleared ([ ]) by clicking the check box,

or by pressing the UP or DOWN ARROW key until the protocol is

highlighted, and then pressing the SPACEBAR.

6. When you finish adding or removing protocols, choose the OK

button. The selected protocols are bound to the network adapter

driver in this network device driver configuration. The Workstation

Configuration dialog box returns, showing the modified configuration.

7. Optionally, from the Workstation Configuration dialog box you can:

• Change the protocol(s) bound to a network adapter driver in

another network device driver configuration (as described earlier in

this section).

• Return to step 2 and add another network device driver

configuration.

• Remove a network device driver configuration (as described later

in this section).

8. When you have completed your review (and your optional changes),

exit the Workstation Configuration dialog box.

• To exit this dialog box and discard any changes you made, choose

the Cancel button. The Setup screen returns. You are finished, and

steps 9 and 10 do not apply.

• To save any changes you made, choose the OK button. Depending

on this computer’s configuration and whether you made changes,

the TCP/IP Settings dialog box (step 9), the Configuration

Complete dialog box (step 10), or the Setup screen appears.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 418 419

Keine Kommentare

Cabletron Systems T2015 Installationsanleitung Seite 98