Cabletron Systems T2015 Installationsanleitung PDF herunterladen (Seite 274)

264 Installation Guide for Clients

ToshibaLAN

Required entry:

• drivername = tsbeth$

The following table summarizes the possible entries and values in the

[tsbether] section of the LAN Manager PROTOCOL.INI file:

Entry Units Range Default

drivername — — tsbeth$

interrupt integer 3, 4, 5, 7, 9,

iobase hex. 200–3E0 280

memorybase hex. C8000–E800

D0000

memorysize — 32, 64 64

Entries in the [tsbether] section of the LAN Manager PROTOCOL.INI

file have the following meanings:

drivername

Identifies the driver name of the network device driver.

interrupt

Indicates the interrupt level of the network adapter. The interrupt

level can be 3, 4, 5, 7, 9, or 10. The interrupt parameter should match

the adapter’s interrupt jumper settings. The default setting is 9.

iobase

Indicates the base I/O address for the network adapter. This address

determines the location of the adapter’s 32 I/O ports. If this entry

does not match the adapter’s I/O address jumper settings, the driver

reports an error. The valid values are 200 through 3E0 by increments

of 20 hexadecimal digits.

memorybase

Specifies the base address for the on-board shared memory (SRAM).

The network- adapter has 64K on-board shared memory used for

buffering the transmit and receive frames. No hardware settings are

required. SRAM configurations cannot cross the 64K boundary; that

is, if the memory size is 64K, the memorybase must start at address

D0000 or E0000.

memorysize

Specifies the size of the shared memory (SRAM). The network

adapter has 64K on-board SRAM. Users can choose to use all of the

memory or half of the memory. A value of 32 indicates 32K, and a

value of 64 indicates 64K. No hardware settings are required. SRAM

configurations cannot cross the 64K boundary; that is, if the memory

size is 64K, the memorybase must start at address D0000 or E0000.

1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 418 419

Keine Kommentare

Cabletron Systems T2015 Installationsanleitung Seite 274