Cabletron Systems T2015 Installationsanleitung PDF herunterladen (Seite 191)

Chapter 9 Network Device Driver Options 181

loopback

Indicates whether to turn off loopback. Use on when the protocol is

ScaNet/NetBIOS for OS/2; use off when using any other protocol.

maxqcb

Specifies the maximum number of queue control blocks for data

transmission.

memaddress

Specifies the start address of the shared RAM on the adapter. This

value must match the configuration of the ScaNet board.

notxownpkt

Specifies whether the driver should suppress its own send.

protocol

Indicates whether or not packets are to be encapsulated in OSI

packets by the protocol software. If this value is tp4, packets are

encapsulated. Use this value when communicating via ScaNet

Routers. If this value is raw, packets are sent without OSI

encapsulation. Use this value when the computer needs to

communicate with other computers that are not using ScaNet-

intelligent adapters.

rxfilter (OS/2 only)

Specifies whether or not data packets are filtered according to

specific parameters. Set rxfilter to off (pass all packets to the driver)

when you have problems running a specific protocol. When this value

is on, only packets containing a valid RXSAP (byte number 15) or

valid typefield (byte 13 to 14) are transmitted via the driver.

Valid RXSAP values are those specified with the rxsap parameter.

Valid typefields are those specified in the rxtype parameter.

rxsap (OS/2 only)

Specifies a list of up to 16 bytes written in hexadecimal values, which

will be added to the list of RXSAP values that is transmitted to the

driver.

rxtype (OS/2 only)

Specifies a list of up to 8 words written as hexadecimal values. These

values are added to the list of RXTYPE values that is transmitted to

the driver.

timeout.boot (OS/2 only)

Determines the period of time, in seconds, that the driver will wait for

the ScaNet board bootload process to complete.

1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 418 419

Keine Kommentare

Cabletron Systems T2015 Installationsanleitung Seite 191