Cabletron Systems T2015 Installationsanleitung PDF herunterladen (Seite 146)

136 Installation Guide for Clients

maxout

Specifies the number of NetBIOS message packets to send before

expecting an acknowledgment. This number is often called the “send

window.”

When the adaptrate entry is present and has a value of zero, the

maxout value is not dynamically adjusted. Otherwise, the NetBEUI

driver adjusts the maxout value as described in the adaptrate entry in

this section.

Set the maxout value to be near but not less than the value of maxin.

If maxout is less than maxin, the t2 timer times out frequently and

wastes link bandwidth.

maxtransmits

Specifies the number of packets the NetBEUI driver can pass at once

to a media-access control driver. If this number is small, the NetBEUI

driver queues the packets internally. If this number is large, the media-

access control driver takes greater responsibility for queuing the

packets.

The value of this entry depends entirely on the capabilities of the

media-access control driver. For more information, see the “Media-

Access Control Drivers” section later in this chapter; many such

drivers have a maxtransmits entry.

mintransmits

Specifies the number of transmission confirmations the NetBEUI

driver must receive from a media-access control driver before sending

more packets, after the media-access control driver returns an “out-

of-resource” condition.

The value of this entry depends entirely on the capabilities of the

media-access control driver, but it should be smaller than the value of

maxtransmits.

The value 0 has the same effect as the value 1.

names

Sets the maximum number of NetBIOS names that can be defined.

One name is always reserved for defining the station address of the

network adapter.

If the NetBEUI driver is bound to more than one media-access

control driver, this entry specifies the number of names each driver’s

name table can have.

For more information about adding names, see the sessions entry in

this section.

ncbs

Specifies the number of NCB descriptors to allocate for managing

NCBs submitted to the NetBEUI driver. Typically, this value is twice

the value for sessions.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 418 419

Kommentare zu diesen Handbüchern

Keine Kommentare

Cabletron Systems T2015 Installationsanleitung Seite 146

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cabletron Systems T2015