Cabletron Systems MT8-MIM Spezifikationen PDF herunterladen (Seite 78)

Chapter 8: Terminal Server Problems

8-8 Troubleshooting Guide

ABCD

Are your routers doing Routing Information Protocol (RIP) broadcasts?

Make the following changes to the config.annex file:

%gateway

net default gateway <ip addr> metric 1 hardwired

where <ip addr> is the IP address of the router port on the same segment as the CSMIM2. You will have

to reboot the CSMIM2.

Did the CSMIM2 reboot?

Call Cabletron Technical Support.

Does netstat -r show routes?

Call Cabletron Technical Support.

Can you ping or Telnet to the host?

Call Cabletron Technical Support.

Congratulations, the problem is solved.

Call Cabletron Technical Support.

Can you ping the IP address of that host?

Are the IP addresses on the same subnet as the CSMIM2?

Enter the

netstat -r command. A list is displayed.

Can you see the subnet in the displayed list?

Check to see if the annex parameter route is set to Y.

Is the route set to Y?

With the CSMIM2 in the Admin Mode, enter the following commands:

admin: set annex route Y

admin: reset annex all

Reboot the system using the following command:

annex# boot -r

Did the CSMIM2 reboot?

Call Cabletron Technical Support.

Does netstat -r show routes?

Are your routers doing Routing Information Protocol (RIP) broadcasts?

(continue)

ABCDE

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 113 114

Keine Kommentare

Cabletron Systems MT8-MIM Spezifikationen Seite 78