Cabletron Systems MT8-MIM Spezifikationen PDF herunterladen (Seite 19)

Troubleshooting Guide 3-1

CHAPTER 3

BOOTING/IMAGE CODE LOADING PROBLEMS

This chapter provides guidelines with some procedures for booting or loading an image code from a PC, or

workstation, to a device such as a management module in a network environment.

In this category of problems, there is only one problem and that is you cannot boot or download an image code

to a device such as a management module. There are several ways to set up a device using the Bootstrap

Protocol (BootP) and transfer an image ﬁle from the server to the device using the Trivial File Transfer

Protocol (TFTP). The method you use depends on the following:

• The management station application being used (such as SPECTRUM Element Manager for Windows

(SPEL) or Remote LANVIEW for Windows) when booting from a PC

• If a UNIX station is being used as a TFTP download server or BootP server

NOTE: The screens shown in this chapter are examples only and may not reﬂect the screens

displayed by your application.

Refer to the following list and then proceed to the appropriate section shown in parentheses for details.

1. TFTP and BootP Download Guidelines for Personal Computers (PC) — (Section 3.1)

2. TFTP Download Guidelines When Using a PC — (Section 3.1.1)

3. TFTP Downloading Using a PC with SPEL — (Section 3.1.2)

4. TFTP Downloading Using a PC with Remote LANVIEW, Version 2.10 — (Section 3.1.3)

5. TFTP Downloading Using a PC with Remote LANVIEW, Version 2.0x — (Section 3.1.4)

6. BootP Downloading Guidelines When Using a PC — (Section 3.2)

7. BootP Downloading Using a PC with SPECTRUM Element Manager — (Section 3.2.1)

8. BootP Downloading Using a PC with Remote LANVIEW 2.10 — (Section 3.2.2)

9. BootP Downloading Using a PC with Remote LANVIEW 2.0x — (Section 3.2.3)

10. TFTP Downloading Guidelines for UNIX Stations — (Section 3.3)

11. Setting Up UNIX Station as TFTP Download Server on Local Subnet — (Section 3.3.1)

12. Setting Up UNIX Station as TFTP Download Server Going Across a Router to the Device —

(Section 3.3.2)

13. Setting Up UNIX Station as BootP Server Going Across a Router to the Device — (Section 3.3.3)

14. Potential Points of Failure When Using a UNIX Station — (Section 3.3.4)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 113 114

Keine Kommentare

Cabletron Systems MT8-MIM Spezifikationen Seite 19