Cabletron Systems RoamAbout Betriebsanweisung PDF herunterladen (Seite 55)

Configuring Your Access Point 4-11

Access Point Installation Menu

The Access Point Installation menu allows you to set parameters when the AP is

initially installed.

NOTE

When installing the AP into a DEChub 90, you must connect the setup port device

to the setup port before applying power to the AP.

NOTE

The installation menu screens depicted in this manual may vary slightly from the

actual screen displays on your setup port device.

===========================================================================

RoamAbout Access Point INSTALLATION MENU

[1] Reset with Factory Defaults

[2] Reset with Current Settings

[3] Show Current Settings

[4] Set SNMP Read/Write Community

[5] Add SNMP Trap Addresses

[6] Delete SNMP Trap Addresses

[7] Dump Error Log

[8] Set In-Band Interface IP Address

[9] Module-Specific Options

===========================================================================

Enter selection :

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 89 90

Keine Kommentare

Cabletron Systems RoamAbout Betriebsanweisung Seite 55