Cabletron Systems RoamAbout Betriebsanweisung PDF herunterladen (Seite 54)

Using the Access Point Setup Port

4-10 Configuring Your Access Point

Using the Access Point Setup Port

After you have completed the setup port cabling, perform the following steps to access

the Access Point Installation Menu.

Step Action

Press on the setup port device a few times until a menu appears.

If the AP is connected to a DEChub 90 or is a standalone unit, the Access

Point Installation Menu appears. Go to the Access Point Installation

Menu section.

If the AP is connected to the MultiSwitch 900 setup port, the Hub

Manager Installation Menu appears (see the following example).

2 Choose option 9; then go to the section titled Start Redirect Mode, as

shown in the following example.

3 After you choose the Start Redirect Mode option, enter the slot

number as shown in the following example.

4 Proceed to the Access Point Installation Menu section.

Return

DIGITAL MultiSwitch 900

=========================================================

DIGITAL MultiSwitch 900 INSTALLATION MENU

[1] Reset with Factory Defaults

[2] Reset with Current Settings

[3] Show Current Settings

[4] Configure IP...

[5] Dump Error Log

[6] Downline Upgrade

[7] Configure Out-of-Band Port...

[8] Start Event Display Mode

[9] Start Redirect Mode...

=========================================================

Enter selection number: 9

Enter selection: 9

=========================================================

Enter the slot number for redirection (1-8): [n]

setup redirected to 3: RoamAbout Access Point

Attempting connection [Ctrl/C to abort]...

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 89 90

Keine Kommentare

Cabletron Systems RoamAbout Betriebsanweisung Seite 54