Cabletron Systems RoamAbout Betriebsanweisung PDF herunterladen (Seite 26)

Reviewing the Site Preparation Checklist

2-2 Preparing for the Installation

Reviewing the Site Preparation Checklist

Before you unpack and install the AP, review the following checklist to ensure that all

site preparation tasks were completed.

General

√ Determine where you will install the AP. Ideally, the AP should be located as high as

possible. For more information, refer to Selecting the Location for the Access Point

on page 2-5.

Hardware

√ Ensure that the Ethernet LAN is in place and operable.

√

If you are installing the AP in a standalone configuration, locate the Ethernet interface

device (for example, a ThinWire segment, DECconnect faceplate, or other appropriate

network device) to which to connect the AP. Otherwise, if you are installing the AP in

a MultiSwitch 900 or DEChub 90, ensure that the device is installed and operable.

√

If you are installing the AP in a standalone configuration, ensure that an appropriate ac

power source is within 1.6 m (5.5 ft) of the AP.

√

Ensure that a setup port device (a terminal or PC with terminal emulation software) or,

a PC to install the RoamAbout Access Point Management Software is available at the

site for configuring the AP.

√

Ensure that network adapters are obtained for each portable PC.

NOTE

Computers equipped with RoamAbout ISA or PCI interface cards can also be used

in your wireless LAN (either along with, or in place of, the wireless clients).

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 89 90

Keine Kommentare

Cabletron Systems RoamAbout Betriebsanweisung Seite 26