Cabletron Systems Access Server 316 Installationsanleitung PDF herunterladen (Seite 82)

SNMP Access Problems

6-4

Problems Accessing the Access Server

Introduction

If you experience problems with your access server responding to SNMP requests from a

network management station (NMS), verify the following:

• SNMP enabled

• Community name access information

• Operations enabled for the community name

• Network configuration

• Communication to a remote NMS

Verify SNMP Enabled

To determine if SNMP is enabled on the access server, enter the following command:

Local> SHOW SNMP

SNMP State: Enabled Authentication Failure: Enabled

Community Name Address GET GETNEXT SET TRAP

PUBLIC ANY ENA ENA DIS DIS

Verify that SNMP State is Enabled. If it is not, enter the following command:

Local> CHANGE SNMP ENABLED

If this command fails, do the following:

Step Action

1 Verify that the Internet address has been set on the access server. See the section

Verify Internet Address (page 3-2).

2 Verify the access server memory usage. See the section Ver if y Access Server Memory

Usage (page 2-6).

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 301 302

Keine Kommentare

Cabletron Systems Access Server 316 Installationsanleitung Seite 82