Cabletron Systems Access Server 316 Installationsanleitung Seite 282
- Seite / 302
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Messages 900 – 999
26-4
Local -914- [protocol] Dump failure, timeout
• Explanation: The access server was unable to send an upline dump file to the load
host. This failure can be caused by either incorrect information on the load host or a
hardware error on the access server..
Local -916- [MOP] Illegal load image - load aborted
Explanation: The problem might be caused by one of the following:
• The access server does not have enough memory to accept the software image.
• The software image is invalid or corrupt.
Step Action
1 If you are using the MOP protocol to downline load the software, do the following:
a. Verify that the information in the NCP database is correct.
At an OpenVMS load host, enter the following command. Substitute the DECnet
node name of the access server for CRC1:
NCP> SHOW NODE CRC1 CHARACTERISTICS
b. Ensure that the DECnet load host for the access server is available and service is
enabled. See the section Verify the Load Host Is Available and Service Is Enabled
(Chapter 1).
2 If you are using the BOOTP and TFTP protocols to downline load the software, do the
following:
a. Ensure that the access server is entered in /etc/bootptab. See the section Ensure
the Access Server Is Entered in /etc/bootptab (Chapter 1).
b. Verify that the BOOTP and TFTP daemons are configured properly.
3 Use the INITIALIZE DIAGNOSE FULL command to verify a hardware error. For
more information on the INITIALIZE command, refer to the Network Access Software
Commands Reference Guide.
Step Action
1 For information on adding memory to your access server, refer to your access server
hardware documentation.
2 Install a new copy of the software image on the load host.
- DECserver 1
- Network Access Software 3
- Problem Solving Guide 3
- Web site: www.dnpg.com 4
- Contents 5
- Chapter 4 SLIP/PPP Problems 6
- Chapter 14 IPX Problems 11
- Chapter 18 Messages 000 – 099 12
- Chapter 26 Messages 900 – 999 14
- Chapter 29 Service Guidelines 14
- Typographical Conventions 16
- Associated Documents 17
- Software WWENG2 MNENG2 WWENG2 20
- Image(s) MNENG3 20
- Verify the Load Host 21
- At an OpenVMS load host: 23
- $ MCR NCP 26
- Downline Load Request Failure 27
- Is Defined Correctly 28
- Messages 29
- $ RUN SYS$SYSTEM:LATCP 33
- Local> SHOW MEMORY STATUS 36
- Low Pool Size: 52480 bytes 36
- Low Pool Used: 1940 bytes 36
- Verify Service Rating 39
- Telnet Resource Problems 43
- Verify Internet Host Name 45
- Telnet Client Hung 50
- SLIP/PPP Problems 55
- SLIP Connection Problems 57
- Verify SLIP Host Address 58
- PPP Connection Problems 65
- Failure Reasons 69
- AppleTalk Access Problems 71
- 3. AppleTalk Gateway Route 72
- Verify AppleTalk Is Enabled 73
- Verify AppleTalk State Is Up 73
- Verify Cache Size Is Correct 74
- Verify Attached Host Software 75
- Local> SHOW PORT 1 ATCP 76
- Local> SHOW PORT 1 76
- Performance Problems 77
- AppleTalk Gateway Route 78
- SNMP Access Problems 79
- Verify SNMP Enabled 82
- Verify Network Configuration 84
- MIB Information 85
- (NMS), do the following: 87
- Reported 89
- Access Problems 91
- TN3270 Connection Problems 92
- Verify TN3270 Keyboard Maps 94
- Telnet Negotiations Problems 97
- Procedure 101
- Authentication Protocol 102
- Overview 109
- Introduction 110
- Verify Internet Address 110
- Local> SHOW SERVER STATUS 111
- Console Port Problems 112
- Problems 113
- Port and Device Problems 114
- Solution 115
- Verify the Port Configuration 127
- Test the Printer Port 128
- LAT Printing Problems 131
- Verify the Print Queue 133
- Verify LAT Group Codes 136
- Telnet Printing Problems 138
- Connection 143
- Listener 145
- Echoes or Double Lines 148
- Modem Configuration Problems 149
- Dial-In User Procedure 151
- Access Server 154
- Not Respond 158
- Does Not Respond 161
- IPX Problems 165
- Network Access Software 167
- Management Guide 167
- Server Port 168
- Accounting Problems 171
- Problems with Accounting Log 172
- Verify Server Console Port 175
- Remote Login Problems 177
- Rlogin Connection Problems 178
- Verify Rlogin Server Username 183
- More Information 185
- Rlogin Client Hung 186
- Suspend IO Sequence 187
- Properly 188
- Some Applications 189
- Directed TFTP Problems 191
- Incorrect Filename 194
- Action: None 197
- >>> b eth:mneng2 197
- Messages 000 – 099 199
- Messages 200 – 299 201
- Corrupted solicit request 209
- Messages 300 – 399 211
- Messages 400 – 499 227
- (Chapter 3) 232
- Messages 500 – 599 243
- Local> INITIALIZE 244
- Messages 600 – 699 249
- Messages 700 – 799 257
- (Chapter 2) 269
- Messages 800 – 899 271
- (Chapter 272
- Messages 900 – 999 279
- Messages 1000 – 1099 291
- Messages 1100 – 1208 293
- Service Guidelines 299
- What To Do 300
- Digital Networks 302
Verwandte Produkte und Handbücher für Vernetzung Cabletron Systems Access Server 316
Vernetzung Cabletron Systems CSX1200 Spezifikationen
(106 Seiten)
(106 Seiten)
Philips Purificador de aire podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Dla domu Philips Purificador de aire.
Dostarczamy 2 pdf podręczników Philips Purificador de aire do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Kommentare zu diesen Handbüchern