Cabletron Systems HSIM-W6 Installationsanleitung PDF herunterladen (Seite 14)

Chapter 2:

About the HSIM-W84

2-2 HSIM-W84 Installation Guide

Additional Features

FLASH EEPROMs —

The HSIM-W84 uses FLASH Electrically Erasable Programmable

Read-Only Memory (EEPROM) that allows the downloading of new and updated ﬁrmware in

conjunction with Cabletron Systems

QuickSET

or any device using BootP or TFTP protocols.

LANVIEW LEDs — Cabletron Systems LANVIEW Status Monitoring and Diagnostics System is

a troubleshooting tool that helps in the diagnosing of power failures, collisions, cable faults, and

link problems. The LANVIEW LEDs are located on the HSIM-W84 front panel.

Remote Management Capabilities

The HSIM-W84 can be remotely managed with any SNMP network management system

including the following:

• Cabletron Systems SPECTRUM for Open Systems Suite of Network Management Products

• Cabletron Systems QuickSET

• Third Party SNMP compliant Network Management Packages

HSIM-W84 Firmware Support

The HSIM-W84 ﬁrmware supports IEEE 802.1d bridging, and IP and IPX routing, and

OSI Layer 2 Inverse Multiplexing (IMUX), which allows the four T1 channels to be used as a

single, high bandwidth, WAN channel.

This device supports industry-standard protocols, security features, compression algorithms and

network management tools to ensure interoperability with equipment from other vendors.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

Keine Kommentare

Cabletron Systems HSIM-W6 Installationsanleitung Seite 14