Cabletron Systems MT8-MIM Spezifikationen Seite 21

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 76
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 20
Device View IRM3 Hubs
SPECTRUM Enterprise Manager Page21 Cabletron Ethernet Hubs
P1 (Port 1 OK)
This LED is lit to indicate that the Network
Interface Chip associated with the IRM-2’s
external repeater port has passed an internal
Loop Back Test and is ready for transmission.
R1(Receive 1)
This LED is located to the left of the P1 LED. It
indicates the IRM2 is repeating a data packet
received from the segment connected to the IRM2
AUI Port or Fiber Optic Port.
LN (Link)
This LED is located below the IRM2’s AUI port. It
indicates that a link has been established
between the fiber optic port on the IRM2 and the
fiber optic device at the other end of the fiber optic
link segment.
IRM3 Hubs
The IRM3 supports LEDs that represent operating
status, collision rates, error rates, packets
transmitted and packets received for the entire
hub as follows.
PW (Power)
This LED is located at the top of the left-hand
LED column. It indicates that the IRM3 is
receiving power from the MMAC.
OK (Board OK)
This LED is located at the top of the right-hand
LED column. If this LED is lit, the module is
operating properly. If this LED is not lit, there is
an initialization problem. You may need to press
the Reset switch.
RC (Receive)
This LED is located below the OK LED. It
indicates that the IRM3 is repeating a packet
received from a connected segment.
MM (Management)
This LED is located below the PW LED. It
indicates that the IRM3 is receiving or
transmitting management packets.
CL (Collision)
This LED is located below the MM LED. It
indicates that a collision has been detected on a
segment.
PO (Port OK)
This LED is located below the RC LED. It
indicates that the internal repeater port is OK.
ON (AUI)
This LED is located above the AUI port and to the
left of the PW LED. It indicates that the AUI port
is the active repeater port.
Seitenansicht 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 75 76

Kommentare zu diesen Handbüchern

Keine Kommentare