Cabletron Systems Spectrum EMM-E6 Betriebsanweisung PDF herunterladen (Seite 15)

Installing the BRIM-F6

BRIM-F6 User’s Guide

Page 2-7

3. Insert the remaining ribbon cable connector into the ribbon cable jack

on the MIM.

4. Press down on the connector until the clips on the jack snap into a

vertical locked position.

After returning the MIM to the chassis, returning power to your hub, and

reconnecting to the network, the BRIM-F6 is now ready for operation.

2.3.2 Installing a BRIM-F6 into a Hub

To install a BRIM-F6 into a stand-alone hub that supports BRIM

technology (e.g., MicroMMAC):

1. Power-down your hub.

2. Disconnect all cables from the hub. Note the port-to-cable

connections.

3. Remove the chassis cover.

Note:

Refer to speciﬁc hub documentation for instructions on removing the

hub chassis cover.

4. Remove the BRIM coverplate/faceplate screws.

Note:

The BRIM-F6 requires an additional 24 pin ribbon connection.

Hubs that support BRIM technology only provide one BRIM slot that

supports this connection. Make sure you install the BRIM-F6 in the BRIM

slot with the ribbon cable jack.

5. Remove BRIM standoff screws.

6. Remove the BRIM coverplate.

7. Place your BRIM behind the hub faceplate. (See Figure 2-3.)

8. Insert the connector pins of the BRIM-F6 into the motherboard

connector in the hub.

BRIM-F Book Page 7 Monday, January 29, 1996 9:26 AM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 42 43

Keine Kommentare

Cabletron Systems Spectrum EMM-E6 Betriebsanweisung Seite 15