Cabletron Systems MT8-MIM Spezifikationen Seite 89
- Seite / 192
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Cabling Types 9-3
Token Ring Media
Figure 9-2. Twisted Pair Signal Equalization
STP cable is made up of four or more wires, and each wire within the cable has a
specific insulator color. These colors are part of the IEEE specifications to which
the cable construction process must be held. Each color identifies a particular
usage for the cable. The four standard colors are black, red, green, and orange.
Table 9-1, below, identifies the type of signal that each wire carries.
STP cabling is available in several different arrangements and construction styles,
called Types. The type definitions are based on the IBM cabling system. STP
cabling that may be used in Token Ring environments falls into four types, called
Type 1, Type 2, Type 6, and Type 9. Any of these cable Categories can be used in a
Token Ring installation, provided that the requisite IEEE 802.5 specifications
regarding the cables are met.
Type 1
Type 1 STP consists of two pairs of solid 22 AWG copper strands. Each strand,
approximately 0.02 inch thick, is surrounded by a layer of insulation. The
characteristics of the insulation is determined by the fire resistance construction of
the cable (plenum cable is thicker and made with slightly different material than
normal PVC cabling).
Table 9-1. STP Cable Wire Identifications
Cable Color Application
Black TX -
Red RX +
Green RX -
Orange TX +
Inverted
Transmission
Normal
Transmission
Induced
Noise Spike
Noise spikes
cancel out
Resulting Signal
Reversion of Inverted
Transmission
Original Signal
1845n05
- Cabletron Systems 1
- Cabling Guide 1
- Contents 5
- Chapter 11 FDDI Media 9
- Introduction 11
- 1-2 Document Organization 12
- Document Conventions 13
- Additional Assistance 14
- Related Documentation 14
- Cabling Terms 15
- 2-2 Physical Components 16
- Connector 17
- 2-4 Physical Components 18
- Physical Components 2-5 19
- Test Characteristics 20
- Test Characteristics 2-7 21
- 2-8 Test Characteristics 22
- Relevant Specifications 23
- Ethernet Media 25
- 4-2 Cabling Types 26
- Coaxial Cable 27
- 4-4 Cabling Types 28
- Unshielded Twisted Pair (UTP) 29
- 4-6 Cabling Types 30
- Cabling Types 4-7 31
- 4-8 Cabling Types 32
- Cabling Types 4-9 33
- 4-10 Cabling Types 34
- Cabling Types 4-11 35
- 4-12 Cabling Types 36
- Cabling Types 4-13 37
- Cabling Types 4-15 39
- 4-16 Cabling Types 40
- 4-18 Connector Types 42
- 4-20 Connector Types 44
- Annular Ring 44
- TRANSCEIVER 45
- 4-22 Connector Types 46
- UTP Cable 47
- 4-24 Connector Types 48
- Connector Types 4-25 49
- TransmitTransmit 50
- ReceiveReceive 50
- Connector Types 4-27 51
- Connector Types 4-29 53
- 4-30 Connector Types 54
- Ethernet Network Requirements 55
- Other Considerations 57
- 10BASE-F (Multimode) 58
- Insertion Loss 59
- Ethernet FOIRL (Single Mode) 60
- Termination 62
- Connectors/Taps 62
- 10BASE5 (Coaxial Cable) 63
- Grounding 64
- Full-Duplex Ethernet Network 65
- Requirements 65
- Insertion Loss (Attenuation) 66
- Fast Ethernet Network 73
- 100BASE-FX (Multimode) 76
- Hybrid Installations 77
- Repeater Classes 78
- Buffered Uplinks 79
- 7-8 Hybrid Installations 80
- 8-4 100BASE-TX 84
- 8-6 100BASE-FX (Multimode) 86
- 9-2 Cabling Types 88
- Cabling Types 9-3 89
- 9-4 Cabling Types 90
- 9-6 Cabling Types 92
- Cabling Types 9-7 93
- Cabling Types 9-9 95
- Connector Types 9-11 97
- 9-12 Connector Types 98
- Connector Types 9-13 99
- BK RE GR OR 100
- Unshielded Twisted Pair Cable 101
- Fiber Optics 103
- Token Ring Media 104
- 9-18 Connector Types 104
- Chapter 10 105
- Impedance 106
- Attenuation 106
- Link Length 107
- Trunk Cable Length 108
- Cable Type 109
- Crosstalk 110
- FDDI Media 115
- 11-2 Cabling Types 116
- Cabling Types 11-3 117
- 11-4 Cabling Types 118
- Shielded Twisted Pair (STP) 119
- 11-6 Cabling Types 120
- STP Cable Quality 121
- Cabling Types 11-9 123
- 11-10 Cabling Types 124
- Connector Types 125
- 11-12 Connector Types 126
- 11-14 Connector Types 128
- Connector Types 11-15 129
- 11-16 Connector Types 130
- FDDI Network Requirements 131
- Emitted Power 132
- TP -PMD (UTP) 134
- TP-PMD (STP) 135
- 12-6 TP-PMD (STP) 136
- Cabling Devices 137
- Hardware Mounting 138
- Enclosed Equipment Cabinet 139
- Cable Termination 140
- Harmonica 141
- Punchdown Block 142
- Distribution Box 143
- Wallplate 144
- Facility Cable Management 145
- 12 11 10 9 8 76543 21 147
- Innerduct 148
- Latching Duct 148
- Labeling Tape 149
- Ty-Wraps and Adhesive Anchors 150
- Connecting and Terminating 151
- 14-2 Ethernet 152
- Ethernet 14-3 153
- 14-4 Ethernet 154
- Ethernet 14-5 155
- 14-6 Ethernet 156
- ST Connector 157
- 14-8 Ethernet 158
- Token Ring 159
- 14-10 Token Ring 160
- Token Ring 14-11 161
- Token Ring MIC 162
- 14-14 FDDI 164
- FDDI 14-15 165
- FDDI MIC 166
- FDDI 14-17 167
- SC Connector 168
- FDDI 14-19 169
- 14-20 FDDI 170
- Charts and Tables 171
- A-2 Ethernet 172
- Ethernet A-3 173
- Token Ring A-5 175
- A-6 FDDI 176
- Glossary-1 177
- Attenuation to Card 178
- Glossary-2 178
- Glossary-3 179
- Channel to Crosstalk 179
- CSMA/CD to Dual Attached 180
- Glossary-4 180
- Glossary-5 181
- Dual Homing to FNB 181
- Frame to Interface 182
- Glossary-6 182
- Glossary-7 183
- Internet to MAU 183
- Mbps to NVRAM 184
- Glossary-8 184
- Glossary-9 185
- Octet to Redundant 185
- Relay to SIMM 186
- Glossary-10 186
- Glossary-11 187
- Switch to UTP 188
- Glossary-12 188
- Numerics 189
Verwandte Produkte und Handbücher für Vernetzung Cabletron Systems MT8-MIM
Vernetzung Cabletron Systems E2100 Spezifikationen
(233 Seiten)
(233 Seiten)
(87 Seiten)
Vernetzung Cabletron Systems MT8-MIM Spezifikationen
(114 Seiten)
(114 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.352 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern