Cabletron Systems RoamAbout Installationsanleitung PDF herunterladen (Seite 37)

Installing the Access Point 3-1

Chapter 3

Installing the Access Point

This chapter provides the procedures to install the Access Point 2000 and its options.

Make sure the site primary power for the Access Point conforms to the specifications

detailed in Chapter 2 - Cabling and Wiring.

If using a BootP/TFTP server and the Access Point Manager to configure the Access Points

with IP addresses, you should configure the server BEFORE applying power to each

Access Point. Upon power-up, each Access Point automatically sends a BootP request.

If you plan to use the Access Point Manager program, write down the MAC address listed

on the front of the Access Point. For a LAN-to-LAN configuration, also write down the

MAC address on the back of the PC Card, which is the wireless MAC address.

In This Chapter

Information in this chapter is presented as follows:

Topic Page

Wall/Ceiling Outlet Box Installation 3-2

Surface Wallmount Installation 3-10

Desktop Installation 3-18

Connecting a Device to the Console Port 3-25

Verifying the Operation of the Access Point 3-27

Configuring the Access Point 3-30

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 67 68

Keine Kommentare

Cabletron Systems RoamAbout Installationsanleitung Seite 37