Cabletron Systems SmartSTACK 10 ELS10-26 Spezifikationen PDF herunterladen (Seite 35)

Enhancements to LCM Commands

2-5

2.5 LCM COMMANDS

The following is a list of commands that were modified for this release:

• Enable Command

• Route Command

•Port Command

• Switch Command

• Trap Control Command

• VLAN Command

Commands are listed alphabetically in this chapter.

2.5.1 Enable Command (Address Limit)

The address limit parameter was added to the enable command. If you set a limit

on a port, the number of end user devices that can have connectivity will be

limited. This is done by limiting the number of MAC addresses that can be

learned on that port.

The format is:

enable [PORT-RANGE [RIP] [TransmitPacing] [ADDRESS_LIMIT]]

The default is “no limit” to the number of addresses that can be learned on a port.

If you set the limit to zero, you allow unlimited access. If you enable a port

without specifying an address limit, you remove the limit that was in effect.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 97 98

Keine Kommentare

Cabletron Systems SmartSTACK 10 ELS10-26 Spezifikationen Seite 35