Cabletron Systems MicroMMAC-44T Betriebsanweisung PDF herunterladen (Seite 37)

INSTALLATION

3-2

Figure 3-1. Attaching the Strain Relief Bracket

3.3 INSTALLING THE MicroMMAC-T

The MicroMMAC-T can be rack-mounted, wall-mounted, or placed on

any horizontal surface. Refer to the following subsections for the

appropriate installation instructions. When installing the MicroMMAC-T

into something other than a 19-inch rack, installation requires the

following:

• An unrestricted free surface area at least 21 inches wide, 18 inches

deep, and 6 inches high.

• A single phase 85 to 264 Vac, 15A, grounded power receptacle located

within 7 feet of the site.

• If a shelving unit is used, it must be able to support 30 pounds of static

weight.

• The temperature in selected location must be between 5° and 50°C,

and change less than 10°C per hour.

NOTE: Be sure that the selected location is within reach of the network

cabling.

3.3.1 Rack-Mounting the MicroMMAC-T

Refer to Figure 3-2 and perform the following steps to install the

MicroMMAC-T in a 19-inch rack:

1. Remove the four cover screws located along the front edges of each

side of the MicroMMAC-T.

TOKEN RING HUB

WITH

LANVIEW®

SUPPORTING 100 OHM STP CABLE

MicroMMAC-24T

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 104 105

Keine Kommentare

Cabletron Systems MicroMMAC-44T Betriebsanweisung Seite 37