Cabletron Systems ST-500 Installationsanleitung

ST-500ETHERNET/IEEE 802.3TRANSCEIVER WITH LANVIEWINSTALLATION GUIDE CABLETRON SYSTEMS, P. O. Box 5005, Rochester, NH 03866-5005

ST-500 INSTALLATION GUIDE Page 2-1 CHAPTER 2INSTALLATION This chapter provides instructions for installing the three types of taps supported by the

CHAPTER 2: INSTALLATION Page 2-2 ST-500 INSTALLATION GUIDE 2.3 Installation Site To install the ST-500 transceiver, a minimum area of 17.8-cm (7-

Installing the Transceiver TapST-500 INSTALLATION GUIDE Page 2-3 Once the power is on at the host system, the SQE LED will be lit on each transceiv

CHAPTER 2: INSTALLATION Page 2-4 ST-500 INSTALLATION GUIDE Figure 2-2. Non-Intrusive Tap KitPWRSQEXMTRCVCLNPRESSURE SCREWCLAMP SECTIONBRAIDPICKSE

Installing the Transceiver TapST-500 INSTALLATION GUIDE Page 2-5 2. Insert the braid picks into the holes in the cable bed as shown in Figure 2-3.F

CHAPTER 2: INSTALLATION Page 2-6 ST-500 INSTALLATION GUIDE 5. Drill a hole in the cable for the center probe. Insert the drill end of the hand co

Installing the Transceiver TapST-500 INSTALLATION GUIDE Page 2-7 Figure 2-6. Installing the Center Probe7. With the center probe installed, the tra

CHAPTER 2: INSTALLATION Page 2-8 ST-500 INSTALLATION GUIDE Figure 2-7. Installing the Tap9. Check the tap using an ohmmeter. The dc resistance be

Installing the Transceiver TapST-500 INSTALLATION GUIDE Page 2-9 require cutting the network cable and installing male-mating connectors to attach

CHAPTER 2: INSTALLATION Page 2-10 ST-500 INSTALLATION GUIDE Figure 2-9. Installing the Tap2. Insert and tighten the flat-head screws (see Figure

ST-500 INSTALLATION GUIDE i NOTICE Cabletron Systems reserves the right to make changes in specifications and other information contained in this

Connecting the Transceiver to the HostST-500 INSTALLATION GUIDE Page 2-11 2.6 Connecting the Transceiver to the Host The ST-500 Transceiver is desi

CHAPTER 2: INSTALLATION Page 2-12 ST-500 INSTALLATION GUIDE 2.7 Checking the Installation Power up the host system. The LANVIEW LEDs on the trans

ST-500 INSTALLATION GUIDE Page 3-1 CHAPTER 3TROUBLESHOOTING This chapter provides troubleshooting information based on the cond

CHAPTER 3: TROUBLESHOOTING Page 3-2 ST-500 INSTALLATION GUIDE Table 3-1 lists the more common error conditions displayed on the LAN-VIEW LEDs alo

TroubleshootingST-500 INSTALLATION GUIDE Page 3-3 Condition 3 - PWR on, XMT , RCV , and CLN on (simultaneously). Note: This is a normal c

ST-500 INSTALLATION GUIDE Page A-1 APPENDIX AST-500 TRANSCEIVER SPECIFICATIONSThis appendix provides the specifications for the ST-500 Transceiver.A

APPENDIX A: ST-500 TRANSCEIVER SPECIFICATIONSPage A-2 ST-500 INSTALLATION GUIDEA.3 Collision Detector SpecificationDelay Time (Input to Output):Start

Power SpecificationST-500 INSTALLATION GUIDE Page A-3A.4 Power Specification Collision DC Threshold: -1566 mV -1510 to 1591 mVInterframe Test

APPENDIX A: ST-500 TRANSCEIVER SPECIFICATIONSPage A-4 ST-500 INSTALLATION GUIDEA.5 Interface Connector Pinout IdentificationThe ST-500 transceiver is

Environmental SpecificationsST-500 INSTALLATION GUIDE Page A-5A.6 Environmental SpecificationsNon-Operating Temperature: -20° C (-4° F) to +90°

ii ST-500 INSTALLATION GUIDE FCC NOTICE This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (

APPENDIX A: ST-500 TRANSCEIVER SPECIFICATIONSPage A-6 ST-500 INSTALLATION GUIDEA.7 Service SpecificationA.8 Physical SpecificationThe following dimen

ST-500 INSTALLATION GUIDE iii VCCI NOTICE This equipment is in the 1st Class Category (information equipment to be used in commercial and/or indust

ST-500 INSTALLATION GUIDE v TABLE OF CONTENTS CHAPTER 1 INTRODUCTION 1.1 ST-500 Features ...

ST-500 INSTALLATION GUIDE Page 1-1 CHAPTER 1INTRODUCTION Welcome to the Cabletron Systems’ ST-500 Ethernet/IEEE 802.3 Transce

CHAPTER 1: INTRODUCTION Page 1-2 ST-500 INSTALLATION GUIDE The type of tap provided with the transceiver body defines one of four models of the S

ST-500 FeaturesST-500 INSTALLATION GUIDE Page 1-3 1.1.1 LANVIEW LEDs The ST-500 transceiver has five LANVIEW LEDs that monitor network activity (t

CHAPTER 1: INTRODUCTION Page 1-4 ST-500 INSTALLATION GUIDE Figure 1-2. Collision Test Signal Timing 1.2 Getting Help If there is any additional s